Home > Flashings > Applications: Agricultural Application

Agricultural Application



 
STARTER BOX
  1. Snap chalk line on wall
  2. Must be level
  3. Notch corners 1" at one end of flashing (applies to starter box only)
  4. Overlap pieces 1"
RIDGE ROLL
  1. Install panel
  2. Install large closures
  3. Center ridge roll
  4. Apply caulking on end lap
  5. Screw down ridge roll
  6. End lap 4"
back to top

FASCIA (with or without Stiffener Ribs)
  1. Make fascia cover for size of fascia - check gable and eave
  2. Notch corners 1"
  3. Apply caulking on end lap
  4. Overlap 1"
  5. On larger fascia you may screw to screw flashings
WALL TRANSITION
  1. Order wall transition to match wall panel
  2. Install wall transition over lower wall panel
  3. Lap 1" to 4" caulk end lap
  4. Install upper wall panel over wall transition
back to top

CORNER POST
  1. Install corner drip to eave
  2. Screw to fit height of sheet
  3. Cut wedge from outside corners 1" to 4"
  4. Lap 1" to 4"
INSIDE CORNER
  1. Install J-Trim 2" to 3" away from corner
  2. Slide in wall panel
  3. Install inside corner stitch screw to J-Trim
back to top

CORNER GAP
  1. Install corner drip to eave
  2. Overlap 1" to 4" caulk end lap
  3. Stitch screw to high rib
CORNER GAP (With J-trim)
  1. Install J-Trim
  2. Install corner cap over high rib and J-Trim overlap 1" to 2"
  3. Stitch screw to high rib and J-Trim
END WALL
  1. Install roofing panel
  2. Install large closure
  3. Install flashing nail to wall
  4. Stitch screw to high rib
  5. Install wall panel
back to top

SIDE WALL
  1. Install roof panel
  2. Apply side wall to wall with roofing nail
  3. Stitch screw to top of panel
  4. Where there is no high rib bend pan 90 degrees
PROW GABLE
  1. Install prow flashing, nail flange to substrate
  2. Screw face to fascia
  3. Lap 1" to 4"
  4. Caulk end laps
  5. Apply sealer tape to flanges 4" away from angle
  6. Install sheets 2" to 3" away from start of angle
back to top

GABLE TRIM
  1. In some cases you may have to bend edge of panel up 1".
  2. Fasten with color/plain screws as shown on diagram.
TRACK COVER
  1. White top mount track cover. Used in conjunction with top-mount brackets 646519 (stock colors also available)
back to top

DRIP CAP
  1. Attach flashing with roofing nails
  2. Drip flashing over some windows and doors may have the color on the other side
J-TRIM
  1. Flash - sides of windows
  2. Doors - top of walls
back to top